Technical Specifications 

Assembly and Mounting Dimensions
BASIC Multiplier dimensions

Electrical Specifications

Parameter

Basic Multiplier Specification
Input Frequency < 50 kHz
Input Signal Requirements Signal Level 0º & 90º  7-16 µApp
w/ 1KWLoad
RM 2 - 8 µApp
w/ 1KWLoad
1 X 2 X
Amplitude Ratio 1.0 ± 0.2 1.0 ± 0.1
Duty Cycle 180º ± 18º 180º ± 18º
Phase 90º ± 10º 90º ± 10º
Electrical Hysteresis £0.1 µm
Reference Mark Position Maximum positive current flow from RM + w/ positive equal current flow from 0º  90º
Width From positive equal current flow of 0º 90º 180º ± 60º 
Output driver 75 ALS 194
Max. Output Cable Length Single Ended 25ft. / Differential 50 Ft.
Operating Voltage 5.0 ± 0.25 £ 50mV Ripple
Operating Current £ 80 mA
VOH (High level output voltage)  ³   2.5, IOH = 20 mA
VOL (Low level output voltage) £ 0.5, IOL = -48 mA
IOH (High level output current) 20 mA Max.
IOL (Low level output current) -48 mA Max.
VOD (Differential output voltage) ³ 2V, @ 100 ohm load
Max. Input Cable Length 20 ft.

Wire colors and output signals

Number Color Output Pin No. Input Pin No.
0º (A+) Green 2 8
180º (A-) Yellow 1 7
90º (B+) Blue 4 6
270º (B-) Red 3 5
RI+ (R+) Pink 5 4
RI- (R-) Grey 6 3
VCC Brown 8 10
GND White 7 9
THRU 1 Opt. 10 1
THRU 2 Opt. 9 2

*Differential Digital (DE)
**Single Ended (SE)

Mechanical Specifications

Parameter Specification
Size (Inches) 1.5 X 0.5 X .232
Mounting Hole Pattern See Figure
Sealing

None
Connectors Dual Row 2mm 10 pin Header
Straight: Harwin M22-2020 505 / Amp 2-178751-8
Right angle: Harwin M22-2040 505 / Amp 2-178898-8
Dual row right angle Shrouded Header / Unlatched; Harwin M80-8681022 / Latched: Harwin M80-B61022

Digital output signals

electrical diagram

 
 

-    Policy     AMI Home     Contact Us  -
-  Links To Cool Sites      Email The Sales Desk      Where We Are Located  -

 

© 1987 - 2009 Automation and Metrology, Inc.  All rights reserved.